![]() ![]() Clean your stylus and control vinyl to ensure they are dust free. Swap sides and order new control vinyl ASAP.ĭust is preventing the stylus from tracking in the groove correctly. Your control vinyl is very badly worn and will not track properly, possibly not at all. This section of the control vinyl has been worn and might not track properly. It is recommended that you replace the control vinyl. Connect your turntable or CDJ directly using one cable only. two or more cables linked together)and the signal is being lost. The RCA cables connecting your turntable or CDJ to Serato DJ are piggybacked (ie. Turntable is not grounded and very susceptible to interference. Try and isolate the turntables from the speakers. If you still have this problem try replacing your RCA cables.īass is reaching the stylus and is causing bad turntable vibration. Check your RCA cables are securely connected and your setup is not close to large electrical sources. The right signal has been lost with a noisy loose connection and is receiving left channel crosstalk. If you still have this problem try replacing your RCA cables. Check your RCA cables are securely connected. Serato DJ is receiving a signal but the right channel has been lost with a noisy, loose connection. Serato DJ is receiving a signal but the left channel has been lost with a noisy, loose connection. If this fails you my need to have your turntables serviced. Ensure your cables are properly connected and try swapping headshells. The left and right channels have been summed to mono. If using Turntables, ensure the cables are properly connected, the wires from the cartridge to the headshell are connected and that the headshell connectors are clean and it is screwed in tightly. If using CDJs, ensure that the RCA cables are properly connected. If using an SL box or Mixer with dip-switches, ensure the audio input level is set to phono. If using an SL box or Mixer with dip-switches, ensure the audio input level is set to line.Ī Turntable (phono level) is connected to a line level input. If trouble persists try swapping out your RCA cables.Ī CD Player (line level) is connected to a phono level input. ![]() ![]() Check connections and ensure you've set up correctly. NOTE: For all examples below, the description refers to the image that precedes it. dusty needle and damaged needle) so it is recommended to try all suggested solutions until your problem is solved. Note: Some problems cause similar looking scopes (eg. Following are the most common scope views you may encounter with suggestions to help you solve the problems they can represent. The scopes are a great tool for diagnosing what is happening. Many playback problems that you encounter when using Serato DJ can be attributed to not getting a good reading of the control signal from your vinyl or CDs. The number below gives the current absolute position within the control vinyl or CD. The top right corner shows the current speed in RPM. The bottom left corner is the current threshold setting. The bottom right corner shows the percentage of readable signal – this number should be as close to 100% as possible when your system is calibrated properly.Īt values of less than 85% you may start to experience tracking difficulties. The top left corner of the scope view displays which control signal Serato DJ is reading (the example above shows it is CV02B, which translates as control vinyl, version 2, side B).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |